3 English reviews written for eSUN ePA12-CF Natural
| 5 stars | | 2 | (66%) |
|---|---|---|---|
| 4 stars | | 0 | (0%) |
| 3 stars | | 1 | (33%) |
| 2 stars | | 0 | (0%) |
| 1 Stars | | 0 | (0%) |
Filter reviews:
-
eexo
30 September 2024
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. -
Roland
12 November 2022
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. On my second roll
Rated with 5 out of 5 stars.
This product took some getting used to and tweaking of setting but once sorted its brilliant. You WILL need a filament dryer and it WILL need to be properly dry before every print to get consistent results. I would choose PA12 over PA6 everytime. PA6 absorbed too much moister over time so even though PA6 parts are good off the bed after two weeks they're flimsy and useless, this doesnt happen with PA12 (this product). I print with a 260 degrees hot end, 60 degree bed and I have to print at 95% flow. Dont be surprised if you need slightly odd settings. I also recommend a 0.6mm nozzle as this will take the pressure of the extruder. I'm about to order my second roll!
Was this rating helpful? (6) (0)
-
Dan
03 November 2022
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. G
Rated with 5 out of 5 stars.
Prints very easily on my Qidi X-Max. Dimensions as per design.
Was this rating helpful? (1) (0)
Magazine Articles:
Discover 3DJake:
-
Ireland: Free standard delivery from € 87,90
-
Free
returns More than 10.550 products
We deliver worldwide to
more than 40 countries
Prints fine and durable, but not dimensionally stable
Rated with 3 out of 5 stars.
Prints as easily as any PA12 with CF. Same very tough, very durable properties. But thickess isn't very stable. While printing a 80mm (height)x 150mm (width), 100mm (depth) part, a 80mmx150mm vertical wall that should be to be flat had variations about 1mm due to over/under-extrusion. I had to severely sand it to more-less match the model. This wasn't the case with other filaments PA-CF , so it's not the printer to blame.
For smaller prints should be ok, just done expect it to be precise.
Was this rating helpful? (0) (0)