2 English reviews written for Artillery All Metal Direct-Drive Upgrade
13 customer reviews in all languages
| 5 stars | | 18 | (72%) |
|---|---|---|---|
| 4 stars | | 3 | (12%) |
| 3 stars | | 0 | (0%) |
| 2 stars | | 3 | (12%) |
| 1 Stars | | 1 | (4%) |
Filter reviews:
-
3dchief
12 March 2024
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. -
Ian, Barry UK
27 August 2023
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Artillery SW X2 All Metal Direct Drive Upgrade
Rated with 4 out of 5 stars.
Very easy to fit. The 2 top mounting screws are effectively held 'captive' by the blue cover piece (which will need removing to extract the screws from the old drive and also to place the screws in the new drive). If the printer is laid on it's back (being caeful not to put any weight on the Z-screws) the bottom mounting screw can be placed in it's hole with a tweezer and will simply sit in place whilst tightened . The end of the black ribbon cable pushes into a slot down the centre of a white connection block and the blue clip then pushes on to hold it in place,
Don't forget to re-level and set the z-offset again afterwards since the level distance between the nozzle and probe tips will most likely be different now.
Also, if you are going to use PLA with this All Metal hotend you will probably need to use a temperature 10 to 15 degrees hotter than before and also to reduce the retraction distance (0.8 mm worked for me) to avoid clogging, See https://letsprint3d.net/all-metal-hotends-troubleshooting-guide/
Artillery's QA on this Direct Drive Upgrade doesn't seem that great as my new levelling probe didn't work (giving me a code 999 error) and nether did the LED light. Neither are a big deal though as I simply swapped out the probe for the one on the old drive and aren't really bothered about the light.
I haven't upgraded the firmware yet but other reviews here give details and, if I can update this review later, I will when I have done it.Was this rating helpful? (1) (0)
Magazine Articles:
Discover 3DJake:
-
Ireland: Free standard delivery from € 87,90
-
Free
returns More than 10.100 products
We deliver worldwide to
more than 40 countries
Smooth upgrade, everything seems to work fine
Rated with 5 out of 5 stars.
Upgrade instructions by Artillery are a bit lacking, but it was still easy to do. Didn't upgrade the firmware since I got this mainly to avoid teflon fumes (toxic!), and with stock firmware it's still enough to reach PETG temperatures (did not try that yet).
Works without problem with PLA after some adjustments: increased temp by 5, increased printing speed, decreased retraction a bit.
Works very well.
It's still possible to upgrade the stock with slightly lower total price (you will need to disassemble the whole thing and replace the heat break and the nozzle) but this upgrade is really easy to do AND also leaves you with replacement parts.
The spring with a cog had to be adjusted a bit before fitting, but that's ok, I would keep it at 5 stars since everything worked smoothly.
Was this rating helpful? (0) (0)