4 English reviews written for 3DJAKE TPU A95 Black
40 customer reviews in all languages
| 5 stars | | 68 | (77%) |
|---|---|---|---|
| 4 stars | | 15 | (17%) |
| 3 stars | | 1 | (1%) |
| 2 stars | | 2 | (2%) |
| 1 Stars | | 2 | (2%) |
Filter reviews:
-
Ottakar Chlpik
17 October 2024
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. -
TheMinjus
15 May 2024
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Nice print!
Rated with 5 out of 5 stars.
After getting around voron 2.4, i managed to print so nicely with this filament. will order again.
Was this rating helpful? (0) (0)
-
Alexander
14 September 2023
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Low quality material, no definitive printing specs
Rated with 2 out of 5 stars.
Stringy, hard to get retraction settings right. Will not extrude at 230C, only 245+. Loops of filament in the spool are somewhat glued to each other. Moist out of the box. Compared to Recreus Filaflex on same machine - day and night.
Was this rating helpful? (1) (0)
-
Solak Design
08 September 2023
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. never had this bad of a filament
Rated with 1 out of 5 stars.
prints out of the box ok, absorbs moisture, dry it, it works fine maybe even better then out of the box. good luck printing again after drying 2 times, shit clogged my bambu lab 0,4mm nozzle 6 times already threw the roll in the trash out of frustration. calibrated everything there was to calibrate on this horseshit, but still does not want to come out of the hole
Was this rating helpful? (1) (0)
Magazine Articles:
Discover 3DJake:
-
Ireland: Free standard delivery from € 87,90
-
Free
returns More than 10.100 products
We deliver worldwide to
more than 40 countries
stringy
Rated with 2 out of 5 stars.
I have printed it on prusa mk3 and there it worked fine on the preset that was allready there. But now i bought the bambu lab A1 and there the settings have to be completly different than on the pruse, i have tried to copy them from prusa slicer to bambu studio. But the prints didnt go well. On these settings it works well: Print speed 20 mm/s and support 30 mm/s. The retraction i have set to 3.5mm. I print on a 0,4 nozzle. And the most important setting for me is the temperature of the nozzle, 215!. even if the filament is not dry it will print at 215c
Was this rating helpful? (0) (0)